Tractor Safety Production Tips

First, the safe start of the tractor

1. Check whether the lubricating oil and fuel meet the specified requirements, whether the shift lever is in the neutral position and whether the cooling water is in compliance. Do not start without cooling water. Before the start of winter, add about 70 degrees warm water to warm up. It is forbidden to add a lot of boiling water before starting.

2. When using a gasoline engine to start. The rope is not allowed to be wrapped around the hand, and people are not allowed to stand behind. The human body should avoid the turning surface of the starting wheel. When using the motor to start, the working time of each start shall not exceed 10 seconds. It is strictly forbidden to start the fire directly with metal parts.

3. After the main engine is started, it should run at a low speed to observe the oil pressure and check whether there is any leakage, oil leakage or air leakage.

4. Do not start the tractor with traction or slipping. In case of emergency use under special circumstances, the tractor and the towed vehicle must be rigidly connected to maintain a sufficient safety distance.

5. Do not use an open fire to roast a car; passengers are not permitted.

Second, the tractor fixed operation safety

1. After the engine is started, it must be warmed up at low speed, and the load can only be loaded when the water temperature rises to 60 degrees.

2. Always observe whether the meter, water temperature, oil pressure, and charging circuit work properly.

3. When the engine cooling water tank "open pot". Do not open the water tank cover, do not add cold water, and remove the load so that the engine idles at a low speed.

4. Before the engine stops, the load should be unloaded, and then turn off after running for a few minutes at a low speed. It is forbidden to stop and extinguish at full load.

5. When inspecting, maintaining and troubleshooting, the power must be cut off and shut down.

6. Night operation must ensure lighting effect and safety. Install fireproof cover when working in the field.

Third, the tractor slope safety road

1. The appropriate gear should be selected before and after the descent. No shifts are allowed on the way uphill.

2. No curves are allowed, sharp turns and horizontal slopes are not allowed, and no upslope is allowed.

3. Do not use neutral gear, flameout, or separate clutches when sloping.

4. When hand-held or tracked tractors turn downhill or go beyond obstacles, they must pay attention to reverse operations to prevent deviation or automatic steering.

5. No parking is allowed on the uphill. When the vehicle must be parked, the brake must be locked and reliable measures must be taken to prevent the car from rolling back.

Fourth, the combine harvester safe operation

1. Prior to harvester operations, roads and fields shall be surveyed, and clear marks shall be placed on dangerous sections and obstacles.

2. When maintaining, overhauling and troubleshooting the harvester, it is necessary to cut off the power and carry it out after the engine stalls; when carrying out mechanical maintenance or overhaul under the header, it is necessary to lift the header and secure it with a safety bracket or pad; No open flame lighting is allowed for mechanical or fueling.

3. When unloading food, people are not allowed to enter the granary and are not allowed to use tools such as iron tools to reach into the granary. Grain-grippers are not allowed to reach into the ration.

4. When the plots are transferred, the header shall be lifted to the highest position and locked, and the collection box shall not be used to carry the goods.

V. Safe operation of rotary cultivator

1. Rotary cultivator operations. It is forbidden to insert the blade into the soil or put it into the soil before starting.

2. During the operation, no sharp turns are allowed and no retrogression is allowed. When turning or turning back, the rotary cultivator should be raised first. When the ground is raised and lowered, the speed must be slowed down, and the lift must not be too high. Directional section transmission angle must not exceed 30 degrees.

3. When removing the wraps, debris, or fastening and changing the coulter on the rotary tiller, the power of the rotary tiller must be cut off before the engine stalls.

4. When the walking tractor turns on the ground, he should hold the hand-held rack first, and after the rotary ploughshare is unearthed, separate the steering clutch.

5. When the field is transferred or passed, power must be cut off and the rotary cultivator raised to its highest position. When walking a tractor across the field, the driver is not allowed to sit in his seat.

Sixth, rice transplanter safe operation

1. When the engine starts, the clutch of the main clutch and the insertion part must be placed in the disengaged position.

2. When cutting corners, the power of working parts must be cut off. The rack must be lifted when raising the intercalator.

3. The hands and feet of the mounting staff are not allowed to reach into the insertion and insertion section.

4. When transporting, it is necessary to separate the insertion part clutch and install the transportation wheel and the ground wheel hub.


We are a professional manufacturer and exporter in range of Sexual Stimulant which including Sex pill,sex capsule,sensual granules,sex energy tea,also sex coffee.



In past years,our products had exported to Kuwait,Mexico,USA,Norway,AU,Canada and so on.high quality products and fast delivery were appreciated by our clients.



Any interesting items,pls.do not hesitate to contact me.welcome ODM & OEM.thanks and welcome inquiry.







 


Each kind herbal sex products for man and woman

Sex pill,Sex stimulant,sex energy drink,sensual stimulant

Chengdu Jingke Trading Co., Ltd. , https://www.jkherb.com