Wintering management methods and points for vegetable nursery

Frost means that in the late autumn and early spring season, due to the intrusion of cold air, the temperature dropped sharply. When the temperature dropped below the minimum temperature required for the growth of crops in a short period of time, the crop was subjected to frost damage.

After the fall, the temperature decreased significantly with the frequent intrusion of cold air. Especially at sunny and windless nights or early mornings, radiation heat dissipation increased, and the surface temperature of plants and plants rapidly decreased. When the plant body temperature dropped below 0°C, the plants The cells in the body will dehydrate and freeze and suffer frost damage. We usually call the first frost in autumn the first frost, because the first frost always hurts crops in silence, so there is the title of “fall killer” crop. The lower the temperature is lowered, the more powerful the frost will be and the more serious the damage will be.

Frost damage to crops

Frost damages crops, mainly because low temperatures below 0°C form ice crystals in the intercellular water of the crop cells, and ice crystals continuously absorb the free water of the cells to gradually increase the ice crystals, which results in the reduction of intracellular water and cytoplasm dehydration. , so that the cytoplasm colloidal material coagulation and cells withered. During the formation and growth of ice crystals, mechanical stress is also exerted on the cells and causes mechanical damage. If the frost is light, the crops have not died, the temperature has gradually increased after the frost, and the cells thaw slowly, which can also restore life activities.

Autumn crops such as corn, soybeans, and cotton are very sensitive to frost before they mature. If corn suffers from early frost during the grain filling period, it will not only affect the quality but also reduce the production. When the temperature dropped to 0°C, mild frost occurred in the corn and the leaves were the first to suffer. Corn grouting nourishment is mainly produced by leaves through photosynthesis, the frozen leaves become yellow, affect the photosynthesis of plants, and reduce the production of nutrients. Due to the reduction of nutrients, corn is grout-laden and grain weight is reduced. If the temperature drops to minus 3°C, serious frost will occur. In addition to a large number of leaf injuries, the panicle neck will also be frozen and die. This not only seriously affects the photosynthesis of corn plants, but also cuts off the passage of stalks to the grain and stops the grouting, often resulting in a significant reduction in production.

When the initial frost occurs, if the crop is mature and harvested, it will not cause losses even if the crop is serious. In northern China, early frost often occurs early. The autumn crops have not yet fully matured and are subject to frost damage, resulting in a large area of ​​reduced production.

Early frost occurs in the early stage of crop maturation and directly affects the yield. Even if remedial measures are adopted after the disaster, it is very difficult to recover the losses. Therefore, in regions where heavier damage to primary frosts, cold-tolerant and early-maturing varieties should be selected, sowing time can be reasonably adjusted, and field management can be strengthened. Make sure the crop is fully mature before the frost comes.

Do a good job of defense against the initial frost

Use physical and chemical methods such as smoke, irrigation, spray, shelter forest, and cover to increase temperature or reduce the cooling rate; use drought-resistant varieties, early-maturing varieties, timely sowing, cultivation of strong seedlings, improved soil and other agricultural methods to defend against frost , mitigate harm.

Middle Capacity Black Garlic Machine

Middle Capacity, such as 200kg Black Garlic Machine is also very popular.It's output is about 100kg black garlic for each batch prodcution.


Black Garlic Machine is widely used for making whole black garlic, solo black garlic and so on. It's process cycle is about 20days for one batch.

We use anhyrous fermenting technology to make black garlic so we don't need to prepare water pipe .We just need to control fermenting time and temperature.

Fresh Black Garlic Fermentation Machine,Aged Black Garlic Machine,Farm Black Garlic Maker Machine,Industrial Black Garlic Fermenter Machine

Zhucheng Tongxi Commercial And Trade Co.,Ltd. , https://www.blackgarlicgroup.com