Frozen fish portion is the part of all
kinds of fishes, like fillet, roe, milt and so on. This category contains the
following products: Frozen Mackerel Fillet Piece, Mackerel Butterfly Fillet
Piece, Frozen Spanish Mackerel Fillet, Frozen Mahi Mahi Fillet, Frozen Mullet
Gutted, Frozen Mullet Roe, Frozen Mullet Milt, Frozen Mullet Gizzard, Frozen
Cooked Frigate Tuna Meat and Frozen Cooked Tuna Meat.
R & D and innovation is the focus of
modern enterprise, so our company have established cooperative relationship
with some famous universities like Zhejiang University of Technology and
Shanghai Ocean University and so on.
We will always strive to create more
delicious, natural and safer marine health food.
Frozen Fishes Portion,Frozen Mackerel Fillet Piece,Frozen Spanish Mackerel Fillet,Frozen Cooked Tuna Meat TAIZHOU XINGWANG AQUATIC PRODUCT CO., LTD. , http://www.tzxingwang.com
Drainage Pump Common Faults
The reason why the pump does not turn during start-up is that the packing is too tight or the impeller and the pump body are jammed and blocked by debris; or the pump shaft, bearing, and the leakage reduction ring are rusted; or the pump shaft is seriously bent. Remedy: Relax the packing and clear the sink. Remove the pump body to remove debris and remove rust; remove the shaft calibration or replace the shaft with a new one. The reason why the water pump does not flow out after start-up is because there is air in the pump or the water in the inlet pipe, or the bottom valve is closed and the water is not filled properly, the vacuum pump packing is seriously leaking, and the gate valve or flap door is not closed. Remedy: Remove debris, replace the damaged rubber pad, change the direction of the valve; compact or replace the new filler, close the valve or shoot the door; increase the amount of irrigation, until the deflation screw plug is not a bubble; Replace the cracked pipe; reduce the lift and press the pump nozzle into the water for 0.5m. Insufficient flow after start-up Cause: The speed is not matched or the belt slips and the speed is low; the installation angle of the axial pump blade is too small; the lift is insufficient; the suction lift is high; the bottom valve, pipe and impeller are partially blocked or the impeller is missing; Water leaks are serious. Remedy: Restore the rated speed, remove the belt grease, adjust the tightness of the belt; adjust the blade angle to reduce the installation position of the pump; seal the leakage point of the pump, press the packing; clear the blockage, replace the impeller; replace the leakage reduction ring, plug Leakage. Cause of water pump heating: bearing damage; clearance of rolling bearing or bracket cover is too small; axis of the pump shaft is bent or the two axes are not uniform; tape is too tight; oil or oil is not good; the balance hole on the impeller is blocked, the impeller loses balance, and increases. The thrust to the side. Remedy: replace the bearing; remove the back cover, install the gasket between the bracket and the bearing seat; investigate the pump shaft or adjust the concentricity of the two shafts; properly loosen the tightness of the tape; add clean butter, butter to occupy the bearing 60% of the internal void; clear the plug in the balance hole. (Zhang Dake)